Monographs: Dosage forms: Specific monographs: Dexamethasone tablets (Dexamethasoni compressi)

Category. Adrenal hormone.

Additional information. Strengths in the current WHO Model list of essential medicines: 500 μg, 750 μg, 1,5 mg, 2 mg and 4 mg. Strengths in the current WHO Model list of essential medicines for children: 500 μg, 750 μg, 1,5 mg, 2 mg and 4 mg.

Requirements

Comply with the monograph for Tablets.

Dexamethasone tablets contain not less than 90.0% and not more than 110.0% of the amount of C22H29FO5 stated on the label.

Identity tests

  • Either tests A and D or tests B, C and D may be applied.

To a quantity of the powdered tablets equivalent to about 20 mg of Dexamethasone add 50 mL of chloroform R and shake for 30 minutes. Filter, evaporate the filtrate to dryness and dry the residue at 105 °C for 2 hours. Use the residue for the following tests.

A. Carry out the examination with the residue as described under 1.7 Spectrophotometry in the infrared region. The infrared absorption spectrum is concordant with the spectrum obtained from dexamethasone RS or with the reference spectrum of dexamethasone.

B. Carry out the test as described under 1.14.1 Chromatography, Thin-layer chromatography using kieselguhr R1 as the coating substance and a mixture of 9 volumes of acetone R and 1 volume of formamide R to impregnate the plate, dipping it about 5 mm into the liquid. After the solvent has reached a height of at least 16 cm remove the plate from the chromatographic chamber and allow it to stand at room temperature until the solvent has completely evaporated. Use the impregnated plate within 2 hours, carrying out the chromatography in the same direction as the impregnation. Use chloroform R as the mobile phase. Apply separately to the plate 2 μl of each of 3 solutions in a mixture of 9 volumes of chloroform R and 1 volume of methanol R containing (A) 2.5 mg of the residue per mL, (B) 2.5 mg of dexamethasone RS per mL and (C) a mixture of equal volumes of solutions A and B. Develop the plate for a distance of 15 cm. After removing the plate from the chromatographic chamber allow it to dry in air until the solvents have evaporated, heat at 120 °C for 15 minutes and spray the hot plate with sulfuric acid/ethanol TS. Heat at 120 °C for a further 10 minutes, allow to cool and examine the chromatogram in daylight and in ultraviolet light (365 nm).

The principal spot obtained with solution A corresponds in position, appearance and intensity with that obtained with solution B. A single spot is obtained with solution C.

C. Transfer a solution containing about 0.2 mg of the residue in 2.0 mL of ethanol (~750 g/l) TS to a stoppered test-tube, add 10 mL of phenylhydrazine/sulfuric acid TS, mix, heat in a water-bath at 60 °C for 20 minutes and cool immediately. The absorbance of a 1 cm layer at the maximum at about 423 nm is not less than 0.40.

D. Transfer about 10 mg to a porcelain crucible, add 45 mg of magnesium oxide R and ignite until an almost white residue is obtained. Allow to cool, add 2.0 mL of water, 0.05 mL of phenolphthalein/ethanol TS and 1.0 mL of hydrochloric acid (~70 g/l) TS. Filter, to the filtrate add a freshly prepared mixture of 0.10 mL of sodium alzarinsulfonate (1 g/l) TS and 0.10 mL of zirconyl nitrate TS, mix and allow to stand for 5 minutes. Repeat the test without the substance being examined. A yellow colour is produced in the solution of the substance being examined and the reagent blank turns red.

Assay

Weigh and powder 20 tablets. To a quantity of the powder equivalent to about 4.0 mg of Dexamethasone add 15 mL of water and shake with four quantities, each of 25 mL, of chloroform R. Filter the chloroform layers through cotton wool, previously washed with chloroform R, and add sufficient chloroform R to produce 200 mL. Transfer 10 mL of the resulting solution to a glass-stoppered 50 mL conical flask, carefully evaporate to dryness and dissolve the residue in 20 mL of dehydrated ethanol R. Add 2.0 mL of blue tetrazolium/ ethanol TS and displace the air in the flask with oxygen-free nitrogen R. Immediately add 2.0 mL of tetramethyl ammonium hydroxide/ethanol TS and again displace the air with oxygen-free nitrogen R. Stopper the flask, mix the contents by gentle swirling and allow to stand for 1 hour in a water-bath at 30 °C. Cool rapidly, add sufficient aldehyde-free ethanol (~750 g/l) TS to produce 25 mL and mix. Measure the absorbance of a 1 cm layer at the maximum at about 525 nm against a solvent cell containing a solution prepared by treating 10 mL of aldehyde-free ethanol (~750 g/l) TS in a similar manner.

Calculate the percentage content of C22H29FO5 by comparison with dexamethasone RS, similarly and concurrently examined.

Uniformity of content

To 1 tablet add 15 mL of water and shake until the tablet is completely disintegrated. Extract with four quantities of 1 mL of chloroform R, filter the chloroform layers through cotton wool, previously washed with chloroform R, and add sufficient chloroform R to produce 50 mL. Transfer a volume of this solution, equivalent to about 200 μg of Dexamethasone, to a glass-stoppered 50 mL conical flask, carefully evaporate to dryness and dissolve the residue in 20 mL of dehydrated ethanol R. Add 2.0 mL of blue tetrazolium/ethanol TS and displace the air in the flask with oxygen-free nitrogen R. Immediately add 2.0 mL of tetramethyl ammonium hydroxide/ethanol TS and again displace the air with oxygen-free nitrogen R. Stopper the flask, mix the contents by gentle swirling and allow to stand for 1 hour in a water-bath at 30 °C. Cool rapidly, add sufficient aldehyde-free ethanol (~750 g/l) TS to produce 25 mL and mix. Measure the absorbance of a 1 cm layer at the maximum at about 525 nm against a solvent cell containing a solution prepared by treating 10 mL of aldehyde-free ethanol (~750 g/l) TS in a similar manner.

Calculate the tablet content of C22H29FO5 in mg by comparison with dexamethasone RS, similarly and concurrently examined. The tablets comply with the test for 5.1 Uniformity of content for single-dose preparations.

to previous sectionto next section