Monographs: Pharmaceutical substances: Pyrazinamide (Pyrazinamidum)

Molecular formula. C5H5N3O

Relative molecular mass. 123.1

Graphic formula.

Chemical name. Pyrazinecarboxamide; CAS Reg. No. 98-96-4.

Description. A white or almost white, crystalline powder; odourless.

Solubility. Sparingly soluble in water; slightly soluble in ethanol (~750 g/l) TS.

Category. Antituberculosis drug.

Storage. Pyrazinamide should be kept in a well-closed container.

Requirements

Definition. Pyrazinamide contains not less than 98.5% and not more than 101.0% of C5H5N3O, calculated with reference to the anhydrous substance.

Identity tests

• Either test A alone or tests B, C and D may be applied.

A. Carry out the examination as described under 1.7 Spectrophotometry in the infrared region. The infrared absorption spectrum is concordant with the spectrum obtained from pyrazinamide RS or with the reference spectrum of pyrazinamide.

B. The absorption spectrum of a 10 μg/mL solution, when observed between 230 nm and 350 nm, exhibits a maximum at about 268 nm and another smaller one at 310 nm; the absorbance of a 1-cm layer at 268 nm is about 0.66.

C. Dissolve 0.1 g in 10 mL of water and add 1 mL of ferrous sulfate (15 g/l) TS; an orange-red colour develops turning to blue on the addition of 1 mL of sodium hydroxide (~80 g/l) TS.

D. Boil 20 mg with 5 mL of sodium hydroxide (~200 g/l) TS; ammonia, perceptible by its odour, is evolved.

Melting range. 188-191°C.

Heavy metals. Use 1.0 g for the preparation of the test solution as described under 2.2.3 Limit test for heavy metals, Procedure 3; determine the heavy metals content according to Method A; not more than 20 μg/g.

Sulfated ash. Not more than 1.0 mg/g.

Water. Determine as described under 2.8 Determination of water by the Karl Fischer method, Method A, using about 1 g of the substance; the water content is not more than 5.0 mg/g.

pH value. pH of a 15 mg/mL solution in carbon-dioxide-free water R, 5.0-7.0.

Ammonia. To 20 mL of carbon-dioxide-free water R add 1.0 mL of formaldehyde TS and 0.05 mL of phenolphthalein/ethanol TS, neutralize with carbonate-free sodium hydroxide (0.1 mol/l) VS, if necessary, add 0.50 g of the test substance, and dissolve cautiously while heating. Titrate with carbonate-free sodium hydroxide (0.1 mol/l) VS until a pink colour is obtained; not more than 0.50 mL of carbonate-free sodium hydroxide (0.1 mol/l) VS is required.

Assay. Dissolve about 0.07 g, accurately weighed, in 15 mL of chloroform R and 5 mL of acetic anhydride R, add 0.15 mL of sudan red TS as indicator, and titrate with perchloric acid (0.1 mol/l) VS as described under 2.6 Non-aqueous titration, Method A. Each mL of perchloric acid (0.1 mol/l) VS is equivalent to 12.31 mg of C5H5N3O.

to previous sectionto next section