Monographs: Pharmaceutical substances: Ethionamide (Ethionamidum)

Molecular formula. C8H10N2S

Relative molecular mass. 166.2

Graphic formula.

Chemical name. 2-Ethylthioisonicotinamide; 2-ethyl-4-pyridinecarbothioamide; CAS Reg. No. 536-33-4.

Description. Small yellow crystals or a yellow, crystalline powder; odour, slight.

Solubility. Practically insoluble in water; soluble in methanol R; sparingly soluble in ethanol (~750 g/l) TS; slightly soluble in ether R.

Category. Antileprosy drug.

Storage. Ethionamide should be kept in a tightly closed container.

Additional information. Ethionamide darkens on exposure to light.

Requirements

Definition. Ethionamide contains not less than 98.0% and not more than 101.0% of C8H10N2S, calculated with reference to the dried substance.

Identity tests

• Either tests A and D or tests B, C and D may be applied.

A. Carry out the examination as described under 1.7 Spectrophotometry in the infrared region. The infrared absorption spectrum is concordant with the spectrum obtained from ethionamide RS or with the reference spectrum of ethionamide.

B. Mix 0.05 g with 0.10 g of 2,4-dinitrochlorobenzene R, then transfer 10 mg of this mixture to a test-tube and heat until melted. Cool and add 3 mL of potassium hydroxide/ethanol TS1; a red to orange-red colour is produced.

C. Heat 0.1 g with 5 mL of hydrochloric acid (1 mol/l) VS; the vapours evolved blacken lead acetate paper R.

D. Melting temperature, about 162°C.

Heavy metals. Use 1.0 g for the preparation of the test solution as described under 2.2.3 Limit test for heavy metals, Procedure 3; determine the heavy metals content according to Method A; not more than 20 μg/g.

Sulfated ash. Not more than 1.0 mg/g.

Loss on drying. Dry to constant weight at 105°C; it loses not more than 5.0 mg/g.

Related substances. Carry out the test as described under 1.14.1 Chromatography, Thin-layer chromatography, using silica gel R4 as the coating substance and a mixture of 9 volumes of chloroform R and 1 volume of methanol R as the mobile phase. Apply separately to the plate 10 μl of each of 3 solutions in acetone R containing (A) 20 mg of the test substance per mL, (B) 0.10 mg of the test substance per mL, and (C) 0.04 mg of the test substance per mL. After removing the plate from the chromatographic chamber, allow it to dry in air and examine the chromatogram in ultraviolet light (254 nm). Any spot obtained with solution A, other than the principal spot, is not more intense than that obtained with solution B. Not more than one of any such spots is more intense than that obtained with solution C.

Assay. Dissolve about 0.15 g, accurately weighed, in 50 mL of glacial acetic acid R1, and titrate with perchloric acid (0.1 mol/l) VS as described under 2.6 Non-aqueous titration, Method A. Each mL of perchloric acid (0.1 mol/l) VS is equivalent to 16.62 mg of C8H10N2S.

to previous sectionto next section