Monographs: Dosage forms: Specific monographs: Cloxacillin sodium for injection (Cloxacillini natrici ad injectionem)Description. A white, crystalline powder. Category. Antibacterial drug. Storage. Cloxacillin sodium powder for injections should be protected from light. Labelling. The designation on the container should state the quantity of Cloxacillin sodium in terms of the equivalent amount of cloxacillin. Expiry date. Additional information. Strength in the current WHO Model list of essential medicines: the equivalent of 500 mg of cloxacillin in vials. Cloxacillin sodium powder for injections is hygroscopic. Requirements The powder for injections and the reconstituted solution for injections comply with the monograph for "Parenteral preparations". Definition. Cloxacillin sodium powder for injections is a sterile powder of cloxacillin sodium. The powder is sterilized by a suitable method (see 5.8 Methods of sterilization). The container of Cloxacillin sodium powder for injections contains not less than 90.0% and not more than 110.0% of the amount of C19H17ClN3NaO5S stated on the label. Identity tests • Either tests A and D or tests B, C, and D may be applied.
Specific optical rotation. Use a solution containing a quantity of the powder for injections equivalent to 10 mg of Cloxacillin sodium per mL, and calculate with reference to the anhydrous substance; Clarity and colour of solution. A solution of the powder for injections equivalent to 0.2 g of Cloxacillin sodium in 10 mL of carbon-dioxide-free water R is clear and colourless. (Keep this solution for the "pH value".) Water. Determine as described under 2.8 Determination of water by the Karl Fischer method, Method A, using a quantity of the powder for injections equivalent to 0.25 g of Cloxacillin sodium; the water content is not less than 35 mg/g and not more than 45 mg/g. pH value. pH of the solution prepared above for the test of clarity and colour, 5.0-7.0. Assay Mix the contents of 10 containers and carry out the assay as described. Transfer a quantity of the powder for injections equivalent to about 0.1 g of Cloxacillin, accurately weighed, to a 500-mL flask and dilute to volume with water. Dilute 25 mL to 100 mL with water. Transfer two 2-mL aliquots of this solution into separate stoppered tubes. To one tube add 10 mL of imidazole/mercuric chloride TS, mix, stopper the tube, and place in a water-bath at 60 °C for exactly 25 minutes. Cool the tube rapidly to 20 °C (solution A). To the second tube add 10 mL of water and mix (solution B). Without delay measure the absorbance of a 1-cm layer at the maximum at about 343 nm against a solvent cell containing a mixture of 2 mL of water and 10 mL of imidazole/mercuric chloride TS for solution A and water for solution B. From the difference between the absorbance of solution A and that of solution B, calculate the amount of C19H17ClN3NaO5S in the substance being examined by comparison with cloxacillin sodium RS. In an adequately calibrated spectrophotometer the absorbance of the reference solution should be 0.40 ± 0.02. Bacterial endotoxins. Carry out the test as described under 3.4 Test for bacterial endotoxins; contains not more than 0.40 IU of endotoxin RS per mg of cloxacillin. |