Monographs: Dosage forms: Specific monographs: Ampicillin sodium for injection (Ampicillini natrici ad injectionem)Description. A white or almost white powder. Category. Antibacterial drug. Storage. Ampicillin sodium powder for injections should be protected from light and stored at a temperature not exceeding 25 °C. The reconstituted solution should be used immediately after preparation. Labelling. The label should state the dose as the equivalent amount of anhydrous ampicillin. Expiry date. Additional information. Strengths in the current WHO Model list of essential medicines: 500 mg, 1 g (as sodium salt) in vial. Strengths in the current WHO Model list of essential medicines for children: 500 mg, 1 g (as sodium salt) in vial. Requirements The powder for injections and the reconstituted solution for injections comply with the monograph for Parenteral preparations. Definition. Ampicillin sodium powder for injections is a sterile powder of ampicillin sodium. The powder is sterilized by a suitable method (see 5.8 Methods of sterilization). The container of Ampicillin sodium powder for injections contains not less than 90.0% and not more than 110.0% of the amount of C16H19N3O4S stated on the label. Identity tests
Specific optical rotation. Use a solution containing a quantity of the powder for injections equivalent to 5 mg of Ampicillin sodium per mL in acetate standard buffer TS and calculate with reference to the anhydrous substance; Clarity of solution. A freshly prepared solution of the powder for injections equivalent to 1 g of Ampicillin sodium in 10 mL of water is clear. A similar solution in 10 mL of hydrochloric acid (1 mol/l) VS is also clear. Water. Determine as described under 2.8 Determination of water by the Karl Fischer method, Method A, using a quantity of the powder for injections equivalent to 0.5 g of Ampicillin sodium; the water content is not more than 20 mg/g. pH value. pH of a solution containing a quantity of the powder for injections equivalent to 0.1 g of Ampicillin sodium per mL of carbon-dioxide-free water R, 8.0–10.0. Assay Mix the contents of 10 containers and carry out the assay as described. Dissolve a quantity of the powder for injections equivalent to about 0.12 g of Ampicillin sodium, accurately weighed, in sufficient water to produce 500 mL. Transfer 10 mL of this solution to a 100 mL volumetric flask, add 10 mL of buffer borate, pH 9.0, TS and 1 mL of acetic anhydride/dioxan TS, allow to stand for 5 minutes at room temperature and dilute to volume with water. Transfer two 2 mL aliquots of this solution into separate stoppered tubes. To one tube add 10 mL of imidazole/mercuric chloride TS, mix, stopper the tube and place in a water-bath at 60 °C for exactly 25 minutes. Cool the tube rapidly to 20 °C (solution A). To the second tube add 10 mL of water and mix (solution B). Without delay measure the absorbance of a 1 cm layer at the maximum at about 325 nm against a solvent cell containing a mixture of 2 mL of water and 10 mL of imidazole/mercuric chloride TS for solution A and water for solution B. From the difference between the absorbance of solution A and that of solution B calculate as a percentage the amount of C16H19N3O4S in the powder for injections by comparison with ampicillin RS. In an adequately calibrated spectrophotometer the absorbance of the reference solution should be 0.29 ± 0.02. Bacterial endotoxins. Carry out the test as described under 3.4 Test for bacterial endotoxins; contains not more than 0.15 IU of endotoxin RS per mg of ampicillin. |