Monographs: Pharmaceutical substances: Senna fruit (Sennae fructus)

Alexandrian Senna fruit

Tinnevelly Senna fruit

Description. Odour, slight; taste, first mucilaginous and sweet, then slightly bitter.

Category. Cathartic drug.

Storage. Senna fruit should be kept protected from light and moisture.

Additional information. Even in the absence of light, Senna fruit is gradually degraded on exposure to a humid atmosphere, the decomposition being faster at higher temperatures.

Requirements

Definition. Alexandrian Senna fruit is the dried ripe fruit of Cassia senna L., (C.acutifolia Delile) and Tinnevelly Senna fruit is the dried ripe fruit of Cassia angustifolia Vahl.

Alexandrian Senna fruit contains not less than 3.4% of hydroxyanthracene derivatives and Tinnevelly Senna fruit contains not less than 2.2% of hydroxyanthracene derivatives, both calculated as sennoside B.

Identity test

Cut the fruit into small pieces or powder about 0.5 g, add 10 mL of sodium hydroxide/ethanol TS and boil on a water-bath, dilute with 10 mL of water and filter. Acidify the filtrate with hydrochloric acid (~70 g/l) TS and extract with 10 mL of ether R. Separate the ether layer and shake it with 5 mL of ammonia (~100 g/l) TS; a pink to red colour is produced in the ammonia layer.

Macroscopic examination. Leaflike, flat and thin pods, yellowish green to yellowish brown with a dark brown central area, oblong or reniform.

Alexandrian Senna fruit. Pale to greyish green; length, about 40-50 mm; width, 20-25 mm; stylar point at one end, containing 6-7 obovate green to pale brown seeds, with longitudinal prominent ridges on the testa.

Tinnevelly Senna fruit. Brown to greyish black; length, about 35-60 mm; width, 14-18 mm; stylar point at one end, containing up to 10 obovate green to pale brown seeds, with indefinite transverse ridges.

Microscopic examination. Epicarp with very thick cuticularized isodiametrical cells, occasional anomocytic or paracytic stomata, and very few unicellular and warty trichomes; hypodermis with collenchymatous cells; mesocarp with parenchymatous tissue containing a layer of calcium oxalate prisms; endocarp consisting of thick-walled fibre, mostly perpendicular to the longitudinal axis of the fruit, but the inner fibres running at an oblique angle or parallel to the longitudinal axis. Seeds, subepidermal layer of palisade cells with thick outer walls; the endosperm has polyhedral cells with mucilaginous walls.

Water-soluble extractive. Shake 5 g with a mixture of 0.5 mL of chloroform R and 200 mL of water, filter, evaporate 20 mL of the filtrate and weigh; the residue is not less than 250 mg/g.

Acid-insoluble ash. Carry out the procedure as described under 4.1 Determination of ash and acid-insoluble ash; not more than 20 mg/g.

Foreign matter. Weigh about 200 g and spread it in a thin layer. Detect the foreign matter by eye or with the use of a 6× lens, separate and weigh; not more than 10 mg/g.

Assay. Place 0.15 g of the powdered fruit in a 100-mL flask. Add 30.0 mL of water, mix, weigh, and place in a water-bath at 80-90°C. Heat under a reflux condenser for 15 minutes. Allow to cool, weigh, and adjust to the original mass with water. Centrifuge and transfer 20.0 mL of the supernatant liquid to a 150-mL separating funnel. Add 0.1 mL of hydrochloric acid (~70 g/l) TS and shake with 3 quantities, each of 15 mL, of chloroform R. Allow to separate and discard the chloroform layer. Add 0.10 g of sodium hydrogen carbonate R and shake for 3 minutes. Centrifuge and transfer 10.0 mL of the supernatant liquid to a 100-mL round-bottomed flask with a ground-glass neck. Add 20 mL of ferric chloride (65 g/l) TS and mix. Heat for 20 minutes under a reflux condenser in a water-bath with the water level above that of the liquid in the flask; add 1 mL of hydrochloric acid (λ420 g/l) TS and heat for a further 20 minutes, with frequent shaking, to dissolve the precipitate. Cool, transfer the mixture to a separating funnel and shake with 3 quantities, each of 25 mL, of ether R previously used to rinse the flask. Combine the ether layers and wash with 2 quantities, each of 15 mL, of water. Transfer the ether layers to a volumetric flask and dilute to 100 mL with ether R. Evaporate 10.0 mL carefully to dryness and dissolve the residue in 10.0 mL of a solution containing 5 mg of magnesium acetate R per mL of methanol R. Measure the absorbance of this solution in a 1-cm layer at the maximum at about 515 nm against a solvent cell containing methanol R. Calculate in % the amount of hydroxyanthracene derivatives as sennoside B with an absorptivity value of 24.0 ( = 240) as follows: 1.25 A/W, where A is the absorbance at 515 nm and W is the mass of the material examined in g.

to previous sectionto next section