Monographs: Pharmaceutical substances: Protionamide (Protionamidum)

Molecular formula. C9H12N2S

Relative molecular mass. 180.3

Graphic formula

Chemical names. 2-propylpyridine-4-carbothioamide (IUPAC); 2-propyl-4-pyridinecarbothioamide (CAS); CAS Reg. No. 14222-60-7.

Description. Yellow crystals or a crystalline powder.

Solubility. Practically insoluble in water; soluble in dehydrated ethanol R and methanol R and acetone.

Category. Tuberculostatic.

Storage. Protionamide should be kept in a tightly closed container, protected from light.

Additional information. Protionamide may exhibit polymorphism.

Requirements

Definition. Protionamide contains not less than 99.0% and not more than 101.0% of C9H12N2S, calculated with reference to the dried substance.

Identity tests

  • Either test A alone or tests B and C may be applied.

A. Carry out the examination as described under 1.7 Spectrophotometry in the infrared region. The infrared absorption spectrum is concordant with the spectrum obtained from protionamide RS or with the reference spectrum of protionamide.

If the spectra thus obtained are not concordant repeat the test using the residues obtained by separately dissolving the test substance and protionamide RS in a small amount of methanol R and evaporating to dryness. The infrared absorption spectrum is concordant with the spectrum obtained from protionamide RS.

B. The absorption spectrum (1.6 ) of a 10 μg/mL solution of the test substance in ethanol (~750 g/L) TS, when observed between 230 nm and 350 nm, exhibits a maximum at about 291 nm and a minimum at 256 nm.

C. Carry out the test as described under 1.14.1 Chromatography, High-performance liquid chromatography using the conditions given under “Related substances”. The retention time of the principal peak in the chromatogram obtained with solution (1) corresponds to the retention time of the peak due to protionamide in the chromatogram obtained with solution (3).

Heavy metals. Use 1.0 g for the preparation of the test solution as described under 2.2.3 Limit test for heavy metals, Procedure 3. Determine the heavy metals content according to Method A; not more than 20 μg/g.

Sulfated ash (2.3). Not more than 1.0 mg/g.

Loss on drying. Dry 1.000 g of the test substance to constant weight at 105 °C; it loses not more than 5.0 mg/g.

Acidity. Dissolve 2.0 g in 20.0 mL of methanol R by warming. Add 20.0 mL of water R, shake and cool to precipitate protionamide. Add 2 drops of cresol red/ethanol TS and titrate with sodium hydroxide (0.1 mol/L) VS. Not more than 0.20 mL is required to obtain the midpoint of the indicator (orange).

Related substances. Carry out the test as described under 1.14.1 Chromatography, High-performance liquid chromatography using a stainless steel column (25 cm ×4.6 mm) packed with particles of silica gel, the surface of which has been modified with chemically-bonded octadecylsilyl groups (5 µm).

Prepare a buffer solution by mixing 2.0 mL of triethylamine R with 1000 mL water and adjusting the pH to 6.0 with phosphoric acid (~105 g/L) TS. As the mobile phase use a mixture of 72 volumes of the buffer solution, and 28 volumes of acetonitrile R.

Operate with a flow rate of 1.0 mL per minute. As a detector use an ultraviolet spectrophotometer set at a wavelength of 290 nm.

Prepare the following solutions in mobile phase. For solution (1) dissolve 50 mg of the test substance in 100.0 mL. For solution (2) dilute 1 volume of solution (1) to 200 volumes. For solution (3) use a solution containing 0.05 mg of protionamide RS and 0.01 mg of ethionamide R per mL.

Inject 20 µL of solution (3). Ethionamide is eluted at a relative retention of about 0.6 with reference to protionamide (retention time about 10 minutes). The test is not valid unless the resolution between the peaks due to ethionamide and protionamide is at least 5.0.

Inject alternately 20 µL each of solution (1) and (2). Record the chromatograms for 2 times the retention time of protionamide.

In the chromatogram obtained with solution (1):

  • the area of any peak corresponding to impurity A (ethionamide), is not greater than the area of the peak due to protionamide in the chromatogram obtained with solution (2) (0.5%);
  • the area of any other impurity peak is not greater than 0.4 times the area of the peak due to protionamide in the chromatogram obtained with solution (2) (0.2%);
  • the sum of the areas of all impurity peaks is not greater than 2 times the area of the peak due to protionamide in the chromatogram obtained with solution (2) (1.0%). Disregard any peak with an area less than 0.1 times the area of the peak due to protionamide obtained with solution (2) (0.05%).

Assay. Dissolve 0.400 g in 30 mL of glacial acetic acid R1 and titrate with perchloric acid (0.1 mol/L) VS as described under 2.6 Non-aqueous titration, Method A. Each mL of perchloric acid (0.1 mol/L) VS is equivalent to 18.03 mg of C9H12N2S.

Impurity

A. 2-ethylpyridine-4-carbothioamide (ethionamide).

to previous sectionto next section